For any family, the decision on what kind of heating and hot water system they are going to install in their home is a very important one. Not only will they probably have to live with it for many years, but also whatever they decide will have a direct effect on their pockets, not so much as regards the installation, but rather in terms of what it is going to cost them to run it.

What should you demand from your chosen heating system?
The ideal heating and/or hot water system for your home should provide a high level of comfort at a reasonable cost; it should be easy to install, leak-proof, appropriate for homes with children or elderly people, clean, smokeless and environmental-friendly; it should not consume oxygen nor require periodic or programmed maintenance or servicing.

Most of the equipment designed to make your home more comfortable and safe runs on electricity. However, there is a common and false belief that electric heating is expensive. Though they may not realise it, users are paying more for their gas heating than they would if they used energy-saving electric heating, and without any additional benefits. In fact, quite to the contrary, they are losing out on the many advantages that electrical powered systems can offer.

For example, many users are probably unaware that during the last year gas prices have been reviewed every three months and that between January and 27 October 2005, prices rose a total of 15%. Under the present legislation, RD 1432/2002 of 27 December, the maximum annual price rise permitted for electricity is 2%. Likewise, users may also not know that under law and for security reasons, gas-fuelled systems must be inspected periodically.

No boiler
Easy installation, no works required. No pollution, ecological. No maintenance. Reduction of up to 50% of energy consumption compared to traditional systems.

No building works
Installation is quick and easy, with small supports screwed to the wall. No building works are required: no tanks, no boiler, no pipes, no pipe conduits, no chimneys. Complete installation in an average flat takes about three hours and the system can be divided into modules, according to the requirements of each room.

No costs
Energy saving due to the heat diffusers' low energy absorption: approximately 50% less than traditional diffusers. High performance, due to the special characteristics of its heat flow: Thermal inertia - during continued use, the power consumption for 10-12 hours of heat emission rarely exceeds 5 hours. Independent heat diffusers, to heat only where heat is needed.

No pollution
Does not modify or dry the atmosphere.
Non-polluting.
Does not produce gases or smoke.
Does not produce any waste.
Does not contaminate the environment.

No boiler
Does not use fuel.
Does not depend on tanks, conduits, etc.
It is odour-free.
Does not stain the walls.
Installation is simple.

No complications
The heat diffusers are not hot to the touch. The high inertia flow provided is non-toxic and non-corrosive.

No maintenance
Heat diffusers are manufactured using injected aluminium and prime quality materials, resistant to wear and corrosion. They are maintenance-free for life.

CLIMATIZACIONES DÉNIA, S.L.
Ctra. Dénia-Ondara, km. 1. · 03700 Dénia (Alicante)
Tel. / Fax: 966 424 169 · info@climatizacionesdenia.com